Fiberglass High Voltage Brake Pull Rod Insulated Pull Rod
Product introduction
Insulated pull rod is suitable for high voltage switch out operating. They are produced from epoxy resin, super light,high voltage, high strength. The length and sections can be made depending on your request.
There are two structural forms of insulating pull rod, one is the flat mouth spiral interface structure, and the multi section insulating rod is fixed and combined through threaded connection, with high strength. The other is a telescopic structure, which can be easily carried by pulling and retracting.
1.Round Shape & High Visibility
2.Improved Universal Head.Easy Maintenance & Lock
3.Easy Disassemble & Ergonomic Design
Insulated Pull Rod Technical Parameters
|
Rated voltage |
Total length |
Node number |
Outer diameter of insulation rod |
thickness |
Combining ways |
|
10KV |
3M |
3 |
32mm |
3.5mm |
Flat mouth spiral |
|
10KV |
4M |
4 |
32mm |
3.5mm |
|
|
35KV |
4M |
4 |
32mm |
3.5mm |
|
|
110KV |
4.5M |
3 |
32/37mm |
3.5mm |
|
|
110KV |
5M |
4 |
32/37mm |
3.5mm |
|
|
220KV |
6M |
3 |
32/37mm |
3.5mm |
|
|
220KV |
6M |
4 |
32/37mm |
3.5mm |
|
|
500KV |
8M |
4 |
32/37mm |
3.5mm |
|
Rated voltage |
Total Length（m） |
Node number |
Retract Length（cm） |
Top rod Thickness（mm） |
Bottom rod thickness（mm） |
Combining ways |
|
10KV |
3 |
3 |
124 |
26 |
38 |
Telescoping |
|
10KV |
4 |
3 |
158 |
3.5mm |
38 |
|
|
35KV |
4 |
4 |
158 |
3.5mm |
44 |
|
|
110KV |
5 |
4 |
159 |
3.5mm |
44 |
|
|
110KV |
6 |
4 |
184 |
3.5mm |
44 |
|
|
220KV |
7 |
4 |
225 |
3.5mm |
44 |
|
|
220KV |
9 |
4 |
232 |
3.5mm |
44 |
|
|
500KV |
10 |
5 |
241 |
3.5mm |
51 |
Related products
-
STEEL STRAND SPLICING SLEEVE PROTECTOR Protecti...
Product introduction Splicing protection sleeve is apply to protecting ground wire pressure crimping tube on steel strand paying off and make it avoid torsion when pass through pulleys. Splicing protection sleeve is composed of two half steel pipes and four rubber heads. It is used to protect the crimping pipe and prevent the crimping tube from directly contacting the pulley and bending during paying off. The splicing protection sleeve must be selected according to ...
-
OUBLE DRUM Four Wheel Tractor TRACTOR WINCH
Product introduction The product is applicable to setting out, tightening, pole erection, take-up, laying cables and other construction work. Fast Speed Double Drum Winch Tractor For Pulling and Lifting During Tower Erection is applicable to pull wire rope and anti twist wire rope.Suitable for the construction of the tower line,traction line,tight line operation,laying cable. The gear consists of low gear and high gear. Both high and low gears have 4 forward gears an...
-
CONDUCTOR EARTH STRINGING BLOCK GROUNDING EARTH...
Product introduction The grounding earthing pulley is applicable to eliminate induced staticelectricity in conductor or grounding wire spread when tensioning erect wires . Notes : The grounding wire shall be configured separately. 1.Toeliminate induce electricity in conductor and grounding wire when releasingwires. 2.Mountedon the outlet side of tensioners or the inlet side of puller, and drawn by twostay grounding wires. 3.Tri-sheave mechanism ,compacted automatica...
-
ACSR Steel Strand CHAIN TYPE Cutting Tools Manu...
Product introduction The conductor cutter is used to cut off various conductor and steel strand. The maximum cut conductor diameter is 35 mm. 1.Cutting the ACSR or steel strand. Type selection shall be based on outer diameter. See the cutting range in the parameter table for details. 2.Because of its light weight, it is easy to carry. It can even be operated with only one hand. 3.The conductor cutter has convenient operation, is labor saving and safe and can not dam...
-
OPGW SHEAVE STRINGING BLOCK Double Wheel Ground...
Product introduction Double Wheel Ground Wire Changing Pulley is suitable for exchanging overhead grounding wire with OPGW operation. The overhead steel strand ground wire is replaced with OPGW by ground wire changing pulley. The pulley is generally made of MC nylon wheels, which is light, wear-resistant and does not damage the wire. Aluminum wheels need to be customized. OPGW MESH SOCK JOINTS TECHNICAL PARAMETERS Item number Model Outing Size （m...
-
Measuring High Voltage Audible Visual Alarm Hig...
Product introduction The high voltage electroscope is made of electronic integrated circuit and has stable and reliable performance. It has the features of full circuit self checking function and strong anti-interference. High voltage electroscope is applicable to the power inspection of 0.4, 10KV, 35KV, 110KV, 220KV, 330KV, 500KV AC power transmission and distribution lines and equipment. It can correctly and reliably inspect power no matter during the day or at ni...